Open the outer cover of the player by lifting up gently on the screen.
Connect your headphones to the jack on the right side of the player labeled with the earphones symbol. Do not connect it to the jack labeled “AUDIO”.
Load the disc you would like to watch as indicated in the Loading Discs section.
Press the “ON” button located in the front right hand corner.
This will power-up the unit and begin the movie. Note: in order to start some
movies, you may be required to use the “SELECT” joystick located on the right
front surface of the player. If so, use the cursor to select the PLAY MOVIE option on
the screen, and press the “ENT” button.
Adjust the volume using the control on the right side of the player and on the headsets to the desired level.
To adjust the size of the picture, press the “MODE” button just below the screen. Your display options are Normal, Full, and Zoom.
Loading Discs
Press the “OPEN” button located in the lower left-hand corner of the player surface. This will open the inner cover.
Place the disk in position, using your finger to push down on the area around the center hole. Make certain the printed side of the disc is facing up
Close the inner cover.
Remove Discs
Press stop.
Press the open button located in the lower left-hand corner of the player surface. This will open the inner cover.
Place your thumb on the center hub of the disc. From the edge of the disc, gently lift the disc upward.
Pausing A Movie
To pause a movie, press the “PLAY/PAUSE” button, located on the front right-hand corner of the player.
To restart, simply press the “PLAY/PAUSE” button again.
Turning The Movie Off
When you are finished with the unit, press the “OFF” button, located on the
right-hand corner by the “ON” button.
Open the outer cover of the player by lifting up gently on the screen.
Connect your headphones to the jack on the right side of the player labeled with the earphones symbol. Do not connect it to the jack labeled “AUDIO”. 
Load the disc you would like to watch as indicated in the Loading Discs section.
Press the “ON” button located in the front right hand corner.
This will power-up the unit and begin the movie. Note: in order to start some
movies, you may be required to use the “SELECT” joystick located on the right
front surface of the player. If so, use the cursor to select the PLAY MOVIE option on
the screen, and press the “ENT” button.
Adjust the volume using the control on the right side of the player and on the headsets to the desired level.
To adjust the size of the picture, press the “MODE” button just below the screen. Your display options are Normal, Full, and Zoom.
